Step One — Prepare Base

After locating and marking the outline for the brick paver patio, set stakes at the four corners. Excavate the area within the stakes to a depth of 4-6 inches. Spread gravel over the entire area, rake smooth, and tamp down to a level surface using a hand or power tamper.



Step Two — Installing Edging

When the gravel base is compact, measure and cut plastic paver edging to the required length to secure the pavers. Lay the edging along the outside border of the patio. Secure in place by hammering 10″ spikes through edging into the ground.


Step Three — Add Sand

Pour sand over the entire area inside the edging to a depth of 1″. Use a rake to evenly distribute it. Using a horizontal 2×4, smooth out and level the surface of the sand.



Step Four — Lay Pavers

Starting at the edging border, begin laying brick pavers. Use a rubber mallet to tap pavers into place. Continue laying pavers following any numbers of patterns until the area in complete. For any irregular spaces, it may be necessary use a hammer and cold chisel to cut them to size.


Step Five — Fill Joints

Spread a thin layer of sand over the entire patio and use a push broom to work it into the gaps between pavers. Soak the patio with a gentle spray of water to help the sand into the gaps. Repeat the process until the sand fill all the gaps. Run a tamper over the patio to set the bricks.